First off just want to say....this is a great site!
It has given the the confidence to try to finish a basement bathroom by my little old self. Dare I say a mud man in the making... more like a mud boy at this point...
Here is the problem...
The room is rough finished with walls and rock. (Cement floor) The center of the toilet drain is only 9" from the wall to center... Hmmm... what to do? Will a 10" rough in toilet fit? In the interest of planning and before I have to do lots of rework, I have tried to come up with a couple of solutions...
1. chip, cut break, remove the concrete and use an offset flange. Seems like a major pain. maybe some code issues as well.
2. since the walls are unfinished. I was thinking or creating a small recess in the wall behind the toilet. Basically I would reframe a box in the wall by turning the studs 90 degrees.. shouldn't be too difficult
BTW.. the wall are not getting tile... just paint most likely
Any better suggestions from anyone??
thanks all
Michael