View Single Post
Unread 01-28-2006, 04:36 PM   #4
shorty
Registered User
 
Join Date: Jan 2006
Location: Central Florida
Posts: 23
Hi, thanks for the replies.

What would I need to use to cut cultured marble with? I was afraid any type of cut would ruin it.

The way it is on the front of the vanity is fine. We have a slight overhang on the front and it is on there level (as far as.. same overhang all around) except this leaves a gap in the back. If we try and push it back against the wall, it will fit in the left hand corner good, but then on the right hand corner, there is about a 1 inch gap. We'd rather have a even gap all the way down the backsplash than none on one end and 1" on the other.

Everything else is even and level. Just the back has the big gap in it.
shorty is offline   Reply With Quote