View Single Post
Unread 05-29-2003, 10:23 AM   #2
Vader,Darth
Registered User
 
Join Date: May 2003
Location: NJ
Posts: 18
Just to clarify-
-the water I used to wash the floor was changed many times
-clean water used in the mixes
-each mix was nearly the same consistency
-the thinset I used was white, but any joints that needed it were scraped, so thinset bleeding through is highly unlikely.
-the tile used was a thin ceramic, about half the thickness of your typical floor tile.
-the floor was set for a week prior to grouting it.

Any suggestions, solutions, or comments as to how this happened and how it may be fixed short of scraping it are most welcome.
Vader,Darth is offline   Reply With Quote