View Single Post
Unread 04-24-2021, 08:08 AM   #28
Shaklee3
Registered User
 
Join Date: May 2018
Location: San Diego, California
Posts: 78
Hi everyone, I ran into somewhat of an issue due to the order I was installing. I've been tiling the walls first so that I could avoid damaging the tile on the floor once I moved to that. I also installed the curb. However, I just realized that I didn't apply the kerdi corner membrane on top of the curb on the side of the curb away from the showerhead. As you can see in the picture here, I have a tile that only has about a 1-in gap on it. What should I do in this case? Should I try to smother the keric with kerdi fix on top and the bottom using thinset, or should I completely remove that one tile and apply it properly?
Attached Images
 
__________________
Cliff

Last edited by Shaklee3; 04-24-2021 at 08:14 AM.
Shaklee3 is offline   Reply With Quote