View Single Post
Unread 03-03-2021, 09:21 PM   #20
jondon
Hershey Pennsylvania Tile Contractor
 
jondon's Avatar
 
Join Date: Dec 2008
Location: Annville - Pennsylvania
Posts: 6,172
Send a message via AIM to jondon
Hi Cliff

Are you an engineer, that looks like an engineer explanation... I read it but it was just way overthinking it imo since you asked.

Because I am very simple I lay out the tile on the floor with the spacing I am going to use. Figuring for the height of the shower pan at the perimeter with the tile on the shower floor figured in. Now knowing the space to tile, I adjust the
top tile and bottom so I have good size pieces. So whatever I figure out the first row of tile to be I start the ledger there. If I am putting the pan in afterwards I calculate for that as well.

So if my pan is going to be 1 1/4" inch at the perimeter height and tile adds 3/8" with thinset I am off the floor 1 1/2" so I measure from there to the height of the first tile and my ledger board goes there. Hope that makes it easier.
__________________

Jon Donmoyer

JD Tile

CTEF Certified Installer #825

Custom Tile Installation in Hershey & surrounding areas

Serving Dauphin, Lebanon, Berks, Chester, & Montgomery Counties PA
jondon is offline   Reply With Quote