View Single Post
Unread 05-06-2021, 12:11 PM   #86
Sclib
Registered User
 
Sclib's Avatar
 
Join Date: Mar 2021
Location: Green Valley, AZ
Posts: 90
First coat RedGard

Primer coat and first coat of RedGard done. In doing this with a rough nap roller as recommended by Custom, there are a lot of little pin holes in the CBU that did not get good coverage. I’m going to need to go back in with the second coat and use a brush to hit the pin holes…….prior to second roller coat.

Also, i went ahead and used fiberglass tape 3/4 of the way up each corner and at the bottom of the niche. This was optional according to the manufacturer but figured it couldn’t hurt.

Getting closer to wall tile!!!

Be safe out there.
Attached Images
 
__________________
“Every day you learn something new is a good day”!!!

Scott
Sclib is offline   Reply With Quote