View Single Post
Unread 03-11-2003, 03:47 PM   #4
Bill Vincent
Tile Contractor
Bill Vincent's Avatar
Join Date: Jan 2003
Location: Bridgton, Maine
Posts: 8,631
No need to measure-- just make sure that most of the bottom tile is on the denshield. As for the tile, a 1/4"x1/4" square notch would be fine with thinset. As for the mesh tape, I meant putting it over EVERY joint involving the denshield.

"Whether you think you can, or you think you can't, you're probably right."
Bill Vincent is offline   Reply With Quote