View Single Post
Unread 06-15-2020, 03:06 PM   #1
Registered User
Join Date: Dec 2015
Location: Berkeley, CA
Posts: 1,110
Different Modifiers Types in Thinset?


My recollection from past reading here is that there are different types of modifiers used in thinsets, and that some modifiers will work fine between two impermeable surfaces. Whereas other modifiers depend on sufficient drying (loss of water) and may take far too long to cure between two impermeable surfaces.

So my general question is whether this is correct, and if so how to tell from a product data sheet which type of modifiers are used? More specifically, will Versabond work adequately to bond Durock Shower System Band to Goboard?

wwhitney is online now   Reply With Quote