Thread: Drilling Tile
View Single Post
Unread 02-26-2007, 11:17 AM   #6
Brian in San Diego
AC Specialist -- Schluterville Graduate
 
Brian in San Diego's Avatar
 
Join Date: Oct 2005
Location: La Quinta, CA and Usk, WA
Posts: 10,791
Tom,

The hole saw I pictured has no center guide drill bit. Either do what Tim suggested (as I did on the sample piece shown) or you angle the edge of the saw and get the hole started and slowly tilt the saw to a vertical position. Variable speed drill is critical here. The only reason I used the angle method is because the hole was about 2 1/2" in diameter and I didn't have a holesaw for wood that was that big.

Brian
__________________
Brian
If that doesn't work, I'll always think it should have.
Brian in San Diego is offline   Reply With Quote