View Single Post
Unread 06-05-2019, 12:49 PM   #17
Fast eddie part deux
Registered User
 
Join Date: May 2019
Posts: 43
Where is that cut edge going to end up ... under shoe mould? Next to a doorway threshold? Are you planning to break the edge with a stone?

Someone mentioned not having a rubber surface on a saw table. Go to home depot, buy a roll of self stick window flashing, its either 4 or 6" wide, stick strips on yur table. Cut out drainage holes to match the casting.
__________________
Ed
Fast eddie part deux is offline   Reply With Quote