Ceramic Tile Advice Forums - John Bridge Ceramic Tile - View Single Post

Bill Vincent · 03-11-2003, 03:47 PM

No need to measure-- just make sure that most of the bottom tile is on the denshield. As for the tile, a 1/4"x1/4" square notch would be fine with thinset. As for the mesh tape, I meant putting it over EVERY joint involving the denshield.

03-11-2003, 03:47 PM	#4
Bill Vincent Tile Contractor Join Date: Jan 2003 Location: Bridgton, Maine Posts: 8,631	No need to measure-- just make sure that most of the bottom tile is on the denshield. As for the tile, a 1/4"x1/4" square notch would be fine with thinset. As for the mesh tape, I meant putting it over EVERY joint involving the denshield. __________________ Bill "Whether you think you can, or you think you can't, you're probably right." http://www.creativeceramicandmarble.com