View Single Post
Unread 05-27-2021, 07:22 PM   #5
Tool Guy - Kg
Moderator -- Wisconsin Kitchen & Bath Remodeler
Tool Guy - Kg's Avatar
Join Date: Feb 2005
Location: Oak Creek, WI
Posts: 22,834
This is a tough one. I don’t see how you could integrate all those joints that run every which way using uniformly-shaped tile and have it look good unless you were to honor the joints below by cutting the tiles to match those joints. Also, how would you deal with the tile-to-sloped coping interface? Stop the tile at the start of the coping and finish the tile edge with a stainless profile like Jim suggested?

Tonto Goldstein... but my friends call me Bubba

Help an awesome summer camp!

Last edited by Tool Guy - Kg; 05-27-2021 at 07:28 PM.
Tool Guy - Kg is offline   Reply With Quote