View Single Post
Old 08-14-2017, 11:32 AM   #49
scottly
Registered User
 
Join Date: Jul 2016
Location: Safety Harbor, Florida
Posts: 57
Here's a pic....Bed is 1 3/4" under the drain flange, 2 1/2" out at the walls. Not perfect, but I was careful to remove any "bulges" between the outer perimeter level line and the drain, so I have a nice, even slope down to the drain, slightly more than a 1/4" per foot. Curb is thin-set to the floor and walls, and is embedded in the mud bed on one side, and the concrete I poured in the floor on the other side to fill the gap created when I moved the curb inward(remember, it'a s sunken shower). The curb is level....and it sits on the sunken part of the shower. I poured fiberglass-reinforced concrete into the gap left by moving the curb.
Attached Images
  
__________________
Scottly

Last edited by scottly; 08-14-2017 at 11:41 AM.
scottly is offline   Reply With Quote