View Single Post
Unread 10-12-2020, 09:11 PM   #5
MesaTileworks
Registered User
 
Join Date: Sep 2008
Location: Staunton, VA
Posts: 150
Thanks for the thread, folks. I have a project coming up with a similar application so this is a good refresher as I've not done one of these in a while.

CX, when you say, "a good method of securing the bottom of the panel where no mechanical fasteners can be used" do you mean that no fasteners should be placed below the level of the the mud of the pan? Would this still be true if the pan was being covered with Kerdi? How far above the level of the pan would you place your first fasteners?

-matt

Sent from my Pixel 2 XL using Tapatalk
MesaTileworks is offline   Reply With Quote