Thread: Rubi Bridge Saw
View Single Post
Unread 11-12-2015, 06:08 PM   #2
bc brick john
Registered User
 
bc brick john's Avatar
 
Join Date: Mar 2007
Location: gibsons sunshine coast BC vancouver
Posts: 249
i have a rubi 250-n which i got used $400 yr old
it only gives a rip of 900mm
and at first it was ok but its now cutting off by over 1/8 to 1/4 with
what ever blade i put in it so it sitting.
i hate the on/off position switch and had one fail costing over $100 to replace.

its not very good either with an over size gap between bed's so doing small cuts is a bit of a joke.

tile guide fence was a complete waste of space and i don't use it.

design of the fold in legs and lifting handle is a joke
and the rolling wheels unless its on a concrete or flat floor

i also have a 3' pearl bridge which is around the same sort of money

but there are better 3-4' rails saws out there now.
look at those but your going into 2K for most of them
__________________
John
Senior Lecturer in Brickwork Masonry
Training instructor/Assessor
brick mason & tile setting
www.stonetilegibsons.ca (under construction)
bc brick john is offline   Reply With Quote