View Single Post
Unread 09-16-2019, 11:36 PM   #3
deejam
Registered User
 
Join Date: Sep 2019
Posts: 4
Thanks much, Tool Guy!

Here is an overview of the back splash wall in question. Fortunately, no corners on this south wall.

I plan to run the tile flush to the ends of the cabinets finished off with trimtec aluminum silver edging.

Here are some measurements:
160 1/4" - full horizontal length to cabinet ends. includes tile and edging
18" to cabinet overhangs
19" to cabinet bottoms
25" to hood bottom
8 3.8" to bottom of window trim

On the full wall pic, the yellow circles indicate were the narrow cuts would be. Far left edge and then both sides of the window. The skinny cuts in these 3 locations would be an close to an inch or just over.

Side note: the trim is not on the window yet, though i did put the left and right pieces in place for the sink pic.The trim will be reinstalled and windows will be painted white before tiling.
Attached Images
  
__________________
Deejam
deejam is offline   Reply With Quote