Thread: Mud shower pan
View Single Post
Old 07-20-2019, 11:19 AM   #51
ZZZK
Registered User
 
Join Date: Mar 2016
Posts: 419
I drill the tile about 3/8 to insure it doesnt hit the water proofing. I measure and cut a stainless screw to go in the hole which will act as a stud to transfer lateral loads to the tile. I mask off the tile around the bracket and fill the hole and coat base of the bracket with laticrete latipoxy 310 stone epoxy. When this setup hardens it is very strong just make sure you fill the hole well and even add some to the screw to ensure a good sploodge pushes out showing good coverage in the hole. I roughen the tile and bracket with a dremel to give the epoxy something to bite on too.
__________________
John
ZZZK is offline   Reply With Quote