View Single Post
Unread 08-12-2009, 05:34 PM   #11
HammerMill88
Registered User
 
Join Date: May 2009
Location: Artesia, MS
Posts: 138
Edit: Nailing 2x's together.

Remember, crown, if any goes up. Pick through and find two good pieces with a very slight crown.

Also, if you have a good table saw. Once you nail them together (watch out for nails sticking through), run them through the table saw to trim the edges even to again aid in support and prevent rolling.

If not table saw. Lay them on top of one another and scribe the one that is larger, then trim with skil-saw. You may have to trim both pieces. IMO, this is an imperative step. Top and bottom need to be flush and flat, within 1/32 at least.
__________________
Joey

"Necessity is the plea for every infringement of human liberty; it is the argument of tyrants; it is the creed of slaves." William Pitt
HammerMill88 is offline   Reply With Quote