View Single Post
Old 03-08-2005, 09:43 PM   #89
Tool Guy - Kg
Moderator -- Wisconsin Kitchen & Bath Remodeler
Tool Guy - Kg's Avatar
Join Date: Feb 2005
Location: Oak Creek, WI
Posts: 20,243
(Holding up right hand) I have never bullnosed slate either, I swear.

You know Jack, I was thinking the same as you and wouldn't consider bullnosing them. I think because of the shaling, I think that it wouldn't come out good, kinda like routing a chippy piece of wood with a router bit and you don't end up with a smooth edge. When I asked, I was thinking that maybe you knocked-off the corner to chamfer it a bit. But now that the others have chimed-in, we are now geniuses and will do it if we need to.

Marni, no finish on it yet. I'll be putting some concoction on it when I get around to it. Probably in 30 years when I retire (although the busiest people I know are does that work?)
Tonto Goldstein….. but my friends call me Bubba
Tool Guy - Kg is offline   Reply With Quote