Ceramic Tile Advice Forums - John Bridge Ceramic Tile

Welcome to John Bridge / Tile Your World, the friendliest DIY Forum on the Internet


Advertiser Directory
JohnBridge.com Home
Buy John Bridge's Books

Go Back   Ceramic Tile Advice Forums - John Bridge Ceramic Tile > Search Forums

Sponsors


Showing results 1 to 25 of 500
Search took 0.21 seconds.
Search: Posts Made By: Kman
Forum: The Mud Box Yesterday, 05:00 PM
Replies: 67
Views: 2,550
Posted By Kman
Is the single wheel on the front? That one took...

Is the single wheel on the front? That one took a pretty good hit.

Looks like you furrowed in for a short distance as well.
Forum: Tile Forum/Advice Board 02-19-2020, 11:59 PM
Replies: 22
Views: 533
Posted By Kman
I hope that's Kerabond T you bought. If it is,...

I hope that's Kerabond T you bought. If it is, you did good.

If it's really Keeshond, I don't know what to tell you. :)
Forum: Tile Forum/Advice Board 02-19-2020, 08:36 AM
Replies: 43
Views: 120,124
Posted By Kman
John, we can always get one sent to you if you...

John, we can always get one sent to you if you can't get it through the online store. I'll send a message to Dave and he'll contact you.

Thanks for your patience. :)
Forum: Tile Forum/Advice Board 02-19-2020, 06:22 AM
Replies: 22
Views: 533
Posted By Kman
There's no rule or best practice about that. I...

There's no rule or best practice about that. I would do at least 2-3", but you can do as much as you want.
Forum: Tile Forum/Advice Board 02-18-2020, 11:03 PM
Replies: 22
Views: 533
Posted By Kman
In his last paragraph, he said he was going with...

In his last paragraph, he said he was going with Kerdiboard and a foam tray.

Certainly nothing wrong with a tray, but a properly installed mud floor works even better, and is a fraction of the...
Forum: Tile Forum/Advice Board 02-18-2020, 10:53 PM
Replies: 22
Views: 533
Posted By Kman
Comparatively speaking, you're lucky. We've seen...

Comparatively speaking, you're lucky. We've seen a lot worse on here.

I've knocked down several that were in use far less time than yours, and suffered much more damage.

Glad you found us. ...
Forum: Tile Forum/Advice Board 02-15-2020, 11:45 PM
Replies: 22
Views: 533
Posted By Kman
More than likely they've done the curb the same...

More than likely they've done the curb the same way with cement board and nails, puncturing the liner every few inches.

Keep tearing out until you don't see any signs of mold, water damage, or bad...
Forum: Tile Forum/Advice Board 02-15-2020, 07:15 PM
Replies: 22
Views: 906
Posted By Kman
I was going to mention this. The laser will...

I was going to mention this. The laser will simply set a level line for you to work from. Where that line is set on the wall depends completely on you.

If you were to start just outside the...
Forum: Tile Forum/Advice Board 02-15-2020, 02:32 PM
Replies: 47
Views: 952
Posted By Kman
Hard to say what he will come up with. Possibly...

Hard to say what he will come up with. Possibly something that will ease your fears so that he'll get paid.

Maybe he'll go along with what you want and will fix everything.

I just don't think...
Forum: Tile Forum/Advice Board 02-15-2020, 01:00 PM
Replies: 47
Views: 952
Posted By Kman
By the way, I wasn't suggesting that you should...

By the way, I wasn't suggesting that you should pay him because he says he's finished and just accept however the job turns out. I'm saying I don't think you can accept the shower as is and refuse...
Forum: Tile Forum/Advice Board 02-15-2020, 12:54 PM
Replies: 47
Views: 952
Posted By Kman
Absolutely it does. :tup2: That's why I...

Absolutely it does. :tup2:

That's why I added that last paragraph.

Denise, I would have a sit-down with the contractor and go over the issues you've discovered. Say that you expect to have...
Forum: Tile Forum/Advice Board 02-15-2020, 11:09 AM
Replies: 47
Views: 952
Posted By Kman
I could not, in good conscience, allow the work...

I could not, in good conscience, allow the work to be completed, have the door installed, and use the shower for however long it ends up lasting, and not pay for it. It would be like buying a car...
Forum: Tile Forum/Advice Board 02-14-2020, 06:06 PM
Replies: 7
Views: 217
Posted By Kman
I'll do a 3/4" thick mud bed over concrete, but...

I'll do a 3/4" thick mud bed over concrete, but I've always set it at 1 1/4" at the drain when going over a framed subfloor.

If it were mine, I'd cut the joists down 2". If I was trying to save...
Forum: Tile Forum/Advice Board 02-14-2020, 09:38 AM
Replies: 7
Views: 217
Posted By Kman
Welcome back, Spencer. :) If memory serves...

Welcome back, Spencer. :)

If memory serves correctly, the mud bed over a subfloor like yours should be a minimum of 1 1/4" thick. So you would need to lower the subfloor more to get the...
Forum: Tile Forum/Advice Board 02-13-2020, 10:19 PM
Replies: 6
Views: 225
Posted By Kman
It doesn't always look dusty on the surface, but...

It doesn't always look dusty on the surface, but every bit of dust you remove gives you a little better bond when setting tile.

But you absolutely need to wipe down any pieces that you've cut with...
Forum: Tile Forum/Advice Board 02-11-2020, 08:57 PM
Replies: 10
Views: 345
Posted By Kman
What we're seeing in that last picture where the...

What we're seeing in that last picture where the tile is removed, is that before or after you cleaned the mortar off the membrane?
Forum: Tile Forum/Advice Board 02-10-2020, 07:52 AM
Replies: 14
Views: 529
Posted By Kman
Right outta the TCNA handbook! :D

Right outta the TCNA handbook! :D
Forum: Tile Forum/Advice Board 02-09-2020, 02:04 PM
Replies: 4
Views: 477
Posted By Kman
My question to them would be, "How many is...

My question to them would be, "How many is enough?"
Forum: The Mud Box 02-08-2020, 11:32 PM
Replies: 67
Views: 2,550
Posted By Kman
Well, he ain't in Arkansas, so I've got no say-so...

Well, he ain't in Arkansas, so I've got no say-so on that. All I can do from here is make friendly suggestions. :)
Forum: The Mud Box 02-08-2020, 06:08 PM
Replies: 67
Views: 2,550
Posted By Kman
Jim, I just saw this part of the thread about...

Jim, I just saw this part of the thread about your incident. Glad you're still with us and at least able to get up and around a little bit. Hope your recovery is swift and relatively pain-free.
...
Forum: Tile Forum/Advice Board 02-08-2020, 08:35 AM
Replies: 9
Views: 250
Posted By Kman
Kerdi doesn't really make a tight corner, so it...

Kerdi doesn't really make a tight corner, so it may be okay. If you have a picture of it we might be able to say for sure.

It's likely that you just pulled it out of the corner when you were...
Forum: Tile Forum/Advice Board 02-07-2020, 06:50 AM
Replies: 45
Views: 1,569
Posted By Kman
I would often set a full tile where it's in plain...

I would often set a full tile where it's in plain sight, ending with a smaller piece at the opposite wall when it's covered or mostly hidden. I don't think that's an issue at all.

If people...
Forum: Tile Forum/Advice Board 02-05-2020, 08:44 AM
Replies: 17
Views: 492
Posted By Kman
My shower is just 6" narrower than yours and I...

My shower is just 6" narrower than yours and I have no problems having just one shower head.
Forum: Tile Forum/Advice Board 02-04-2020, 11:02 PM
Replies: 17
Views: 492
Posted By Kman
That's how I would build it. I'd use 2x4's for...

That's how I would build it. I'd use 2x4's for the frame, cover the top with 3/4" plywood, and the top and front with 1/2" Durock, followed by their membrane.

Don't forget to figure in the...
Forum: Tile Forum/Advice Board 02-03-2020, 09:20 PM
Replies: 75
Views: 2,798
Posted By Kman
It's right here...

It's right here (http://www.ci.punta-gorda.fl.us/government/building).
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 05:58 PM.


Sponsors

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright 2018 John Bridge & Associates, LLC