Ceramic Tile Advice Forums - John Bridge Ceramic Tile

Welcome to John Bridge / Tile Your World, the friendliest DIY Forum on the Internet


Advertiser Directory
JohnBridge.com Home
Buy John Bridge's Books

Go Back   Ceramic Tile Advice Forums - John Bridge Ceramic Tile > Search Forums

Sponsors


Showing results 1 to 18 of 18
Search took 0.00 seconds.
Search: Posts Made By: Eggie
Forum: Tile Forum/Advice Board 03-26-2014, 02:41 PM
Replies: 23
Views: 3,842
Posted By Eggie
Tile Lippage Control

Does anyone sell a tool that can be used to eliminate "lippage" on 18" square porcelain floor tiles? I will be installing the tiles over a Schluter Ditra Underlayment which is already laid-down. I...
Forum: Tile Forum/Advice Board 01-13-2014, 10:36 AM
Replies: 23
Views: 3,842
Posted By Eggie
Countertop to wall tile junction

OK; I'll install my countertop first, then I'll tile my walls. I'll leave a small gap where the bottom of the wall tile meets the top surface of the countertop - then I'll fill the gap with silicone...
Forum: Tile Forum/Advice Board 01-12-2014, 08:00 PM
Replies: 23
Views: 3,842
Posted By Eggie
Countertop to wall tile junction

I plan to tile my bathroom walls with 3 x 6 ceramic subway tiles. I will install a 72" long x 24" deep vanity in one corner of the bathroom. The back of the vanity, and one end, will nestle in one...
Forum: Tile Forum/Advice Board 01-07-2014, 09:49 AM
Replies: 23
Views: 3,842
Posted By Eggie
Tile on the side of a wooden bathroom vanity

Thanks for your response. I'll post some pictures when I get further along.
Forum: Tile Forum/Advice Board 01-06-2014, 02:05 PM
Replies: 23
Views: 3,842
Posted By Eggie
Tile on the side of a wooden bathroom vanity

I would like to apply tile to one side of my bathroom vanity. The vanity side is 5/8" plywood with oak veneer. I would also like to tile the toe-relief area along the bottom/front of the vanity,...
Forum: Tile Forum/Advice Board 12-05-2013, 02:16 PM
Replies: 23
Views: 3,842
Posted By Eggie
I installed 2 x 8 Moldura ceramic tiles on the...

I installed 2 x 8 Moldura ceramic tiles on the perimeter of my wall/ceiling - similar to crown molding. The grout joints are about 1/16" wide. A grout float does not work well on the curved joints....
Forum: Tile Forum/Advice Board 11-25-2013, 09:00 PM
Replies: 23
Views: 3,842
Posted By Eggie
Combining Sanded Grout with Unsanded Grout

I installed 3x6 and 6x6 glazed ceramic tiles on three walls of my Shower. I have grout spaces ranging from slightly less than 1/8" up to 1/4". I purchased Mapi Grout in both the sanded and unsanded...
Forum: Tile Forum/Advice Board 08-21-2013, 02:16 PM
Replies: 23
Views: 3,842
Posted By Eggie
Tinted grout with white marble

I know not to use gray thinset when installing white marble because it can bleed thru and darken the marble. My question is: Will tinted grout darken the marble around the joints? I was planning...
Forum: Tile Forum/Advice Board 05-22-2013, 05:34 PM
Replies: 23
Views: 3,842
Posted By Eggie
Porcelain Bullnose Tile as a Baseboard

I would like to use Porcelain Bullnose tiles as a baseboard around the perimeter of my bathroom. Each tile is 3" wide x 18" long. I would attach the tiles to the wall in place of a traditional wood...
Forum: Tile Forum/Advice Board 05-07-2013, 07:57 PM
Replies: 12
Views: 2,839
Posted By Eggie
Low spots in my shower floor Mud Base

I just finished installing the mud base for my "Schluter Kerdi" shower floor. The floor is 38" x 60" with a "Kerdi Drain" in the center. I sloped the mud base 1/4" per foot as measured from the...
Forum: Tile Forum/Advice Board 01-28-2013, 01:45 PM
Replies: 12
Views: 2,839
Posted By Eggie
Installing a Wall/Ceiling Border Tile

I would like to install a ceramic border (i.q. molding) around the perimeter of my bathroom wall - at the very top of the wall, where it intersects the ceiling. The tile is a 2" Wide x 8" Long white...
Forum: Tile Forum/Advice Board 01-14-2013, 03:54 PM
Replies: 12
Views: 2,839
Posted By Eggie
deck mud under kerdi drain

I posted a couple of questions for the tile forum but haven't got a response. Did I do something wrong (or maybe my questions were not understood). Please help.
Thank you
Eggie
Forum: Tile Forum/Advice Board 01-10-2013, 06:20 PM
Replies: 12
Views: 2,839
Posted By Eggie
deck mud under Kerdi Drain

I am ready to start building my deck mud bed. I will be using a Kerdi Drain and I plan to have 1-1/4" thick bed of mud under the drain. I have 2 questions concerning installation of the Drain:...
Forum: Tile Forum/Advice Board 01-07-2013, 06:56 PM
Replies: 23
Views: 3,842
Posted By Eggie
Floor deflection – please Help! Thanks to all...

Floor deflection – please Help!
Thanks to all who answered my call for help. In response to everyone’s comments, I have decided to abandon my hopes of installing marble on my bathroom floor. I...
Forum: Tile Forum/Advice Board 01-04-2013, 10:35 AM
Replies: 23
Views: 3,842
Posted By Eggie
Floor Deflection

Floor deflection – please Help!
I purchased marble floor tiles for my bathroom – then I found out that marble requires a stiffer floor structure than ceramic tile. I used the Forums...
Forum: Tile Forum/Advice Board 12-20-2012, 06:17 PM
Replies: 12
Views: 2,839
Posted By Eggie
thinsets

What type of thinset, modified or unmodified, to attach "Kerdi" to "PermaBase" cement board? Eggie
Forum: Tile Forum/Advice Board 08-03-2012, 02:45 PM
Replies: 12
Views: 2,839
Posted By Eggie
Waterproofing shower valve

I purchased John Bridges book "Tile Your World" and found it very informative, so I'm ready to start my shower project. I plan to construct my tiled shower using the "Schluter Kerdi" products and...
Forum: Tile Forum/Advice Board 07-31-2012, 10:20 AM
Replies: 12
Views: 2,839
Posted By Eggie
Fiberglass insulation on interior wall

I am remodeling my bathroom and installing a "Kerdi" shower. One of the shower walls adjoins my living room wall. The wall has paper-backed fiberglass insulation installed between the wall studs. ...
Showing results 1 to 18 of 18

 
Forum Jump

All times are GMT -6. The time now is 06:03 AM.


Sponsors

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright 2018 John Bridge & Associates, LLC