Ceramic Tile Advice Forums - John Bridge Ceramic Tile

Welcome to John Bridge / Tile Your World, the friendliest DIY Forum on the Internet


Advertiser Directory
JohnBridge.com Home
Buy John Bridge's Books

Go Back   Ceramic Tile Advice Forums - John Bridge Ceramic Tile > Search Forums

Sponsors


Showing results 1 to 8 of 8
Search took 0.01 seconds.
Search: Posts Made By: jdavis@openactive.org
Forum: Tile Forum/Advice Board 01-25-2023, 04:38 PM
Replies: 16
Views: 1,434
Hey Guys, Been a while! Last spring once...

Hey Guys,

Been a while! Last spring once the walleye run started the bathroom project got put on hold. Picked it back up in December and I'm basically done. Thanks for the help!

I installed...
Forum: Tile Forum/Advice Board 02-16-2022, 07:38 PM
Replies: 16
Views: 1,434
Thanks CX. Noted on the 1/4" of space. I'll try...

Thanks CX. Noted on the 1/4" of space. I'll try my angle grinder tomorrow.

I did remove that plywood. I was using it as a jig to get the drain at the right height and exact center. Here is a...
Forum: Tile Forum/Advice Board 02-16-2022, 07:08 PM
Replies: 16
Views: 1,434
Ah sorry. I'm a total newb here. Thanks for the...

Ah sorry. I'm a total newb here. Thanks for the heads up.

I'm working with 1/2" PermaBase. I'm installing it in my new shower. I have cut a few pieces just slightly too big and wondering if there...
Forum: Tile Forum/Advice Board 02-16-2022, 04:02 PM
Replies: 16
Views: 1,434
Trim Cement Board

Hello!

What is the best way to trim an 1/8" off cement board? If this were drywall I would use a rasp. I tried that on cement board and it has little to no effect. Any suggestions? Thanks!
Forum: Tile Forum/Advice Board 01-14-2022, 09:23 AM
Replies: 16
Views: 1,434
In hindsight I should 100% have tried that out.

In hindsight I should 100% have tried that out.
Forum: Tile Forum/Advice Board 01-14-2022, 08:12 AM
Replies: 16
Views: 1,434
The grinder and cup wheel got the job done. I had...

The grinder and cup wheel got the job done. I had a hard time with the dust collecting. I changed the filters a few times and was constantly having to clean the filter. Is that pretty typical? I...
Forum: Tile Forum/Advice Board 01-06-2022, 07:45 PM
Replies: 16
Views: 1,434
Thanks Lou. I have all that on the way now. Set...

Thanks Lou. I have all that on the way now. Set me back $315 for the 7" Makita Grinder, cup wheel, and dust shroud.
Forum: Tile Forum/Advice Board 01-06-2022, 06:59 PM
Replies: 16
Views: 1,434
Is this good enough? Removing thinset from concrete

Hello!

First time poster, long time lurker. I am finally trying to remodel a bathroom in the basement. I have removed the tile and am now trying to remove the old thinset. I plan on putting new...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -6. The time now is 11:25 PM.


Sponsors

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2023, Jelsoft Enterprises Ltd.
Copyright 2018 John Bridge & Associates, LLC