Ceramic Tile Advice Forums - John Bridge Ceramic Tile

Welcome to John Bridge / Tile Your World, the friendliest DIY Forum on the Internet


Advertiser Directory
JohnBridge.com Home
Buy John Bridge's Books

Go Back   Ceramic Tile Advice Forums - John Bridge Ceramic Tile > Search Forums

Sponsors


Showing results 1 to 25 of 500
Search took 0.28 seconds.
Search: Posts Made By: Davy
Forum: Tile Forum/Advice Board Yesterday, 09:46 AM
Replies: 11
Views: 218
Posted By Davy
Nick, the bottom flange on the 3 pc drain needs...

Nick, the bottom flange on the 3 pc drain needs to be about 3/4 inch higher than the concrete slab height. Use a short straight edge of some sort (2 ft level works good) to bridge across to figure...
Forum: Tile Forum/Advice Board 01-16-2021, 10:53 AM
Replies: 7
Views: 115
Posted By Davy
If he installed two mud beds then it sounds like...

If he installed two mud beds then it sounds like he did put a preslope mud bed under the liner, which is a good thing. Someone still needs to explain to me why adding a paint on membrane to the top...
Forum: Tile Forum/Advice Board 01-16-2021, 10:07 AM
Replies: 15
Views: 278
Posted By Davy
I've used Mercrete products several times, on two...

I've used Mercrete products several times, on two balconies that are still in service. Their products are top notch as far I can tell.

I wonder if the bench has a pitch or if it's close to level....
Forum: Tile Forum/Advice Board 01-15-2021, 05:26 PM
Replies: 6
Views: 140
Posted By Davy
Ditra, is not designed for that. The Ditra won't...

Ditra, is not designed for that. The Ditra won't hang on to the dry pack like lath will. A couple plastic trash bags stapled down will keep moisture away from the wood. No one knows if Ditra alone...
Forum: Tile Forum/Advice Board 01-15-2021, 12:49 PM
Replies: 2
Views: 91
Posted By Davy
Hi Rene, welcome. Bricks vary in thickness...

Hi Rene, welcome. Bricks vary in thickness depending on the brand. I cut bricks on my tile saw (10 inch blade) quite often. I believe they are about 2 1/4 thick. A thicker brick my not cut in one...
Forum: Tile Forum/Advice Board 01-15-2021, 11:29 AM
Replies: 13
Views: 232
Posted By Davy
I like the 18 inch tiles on each side of the back...

I like the 18 inch tiles on each side of the back wall. Then, I would look into using the 6 inch cut off on the side wall to allow the wave in the tile to flow thru the corner. Then you would have a...
Forum: Tile Forum/Advice Board 01-14-2021, 01:58 PM
Replies: 19
Views: 532
Posted By Davy
Since his linear drain is on the left, the slight...

Since his linear drain is on the left, the slight step down just inside the curb area (vertical tiles) will be larger on the left. William, is this what you're talking about?
Forum: Tile Forum/Advice Board 01-14-2021, 01:51 PM
Replies: 3
Views: 90
Posted By Davy
I've never done it but it would probably be best...

I've never done it but it would probably be best to go over the floor tiles with cement board. But, lets get the opinion from others first. Years ago, before we knew better, we removed a lot of those...
Forum: Tile Forum/Advice Board 01-14-2021, 01:28 PM
Replies: 47
Views: 1,251
Posted By Davy
The link I found shows the wire woven into a...

The link I found shows the wire woven into a fiberglass mat like I talked about before. Maybe I didn't dig deep enough. Like you said, they do mention that you may need to mud the floor over the...
Forum: Tile Forum/Advice Board 01-14-2021, 01:16 PM
Replies: 13
Views: 232
Posted By Davy
Si, I'm talking about in a small area. The middle...

Si, I'm talking about in a small area. The middle of your first picture is a good example. That big tile could have been pushed over and a small tile or two added to take away the very large joints....
Forum: Tile Forum/Advice Board 01-14-2021, 12:46 PM
Replies: 3
Views: 90
Posted By Davy
Hi Matt, welcome. If you plan to tile other walls...

Hi Matt, welcome. If you plan to tile other walls and want the new tiles to tie in with the old, the first thing I would do is bring some sample tiles home to make sure they are the same size. The...
Forum: Tile Forum/Advice Board 01-14-2021, 12:12 PM
Replies: 47
Views: 1,251
Posted By Davy
Thanks for clearing that up, I've never used Warm...

Thanks for clearing that up, I've never used Warm up. Can you use the Warm up heated floor with mosaic tiles?
Forum: Tile Forum/Advice Board 01-14-2021, 12:08 PM
Replies: 13
Views: 232
Posted By Davy
What Dan said. Also, if those tiles are on a...

What Dan said. Also, if those tiles are on a sheet or net, in places that have extra large joints, don't be afraid to cut them out and place them closer or add a few smaller tiles if you need to.
Forum: Tile Forum/Advice Board 01-14-2021, 11:00 AM
Replies: 16
Views: 281
Posted By Davy
If you don't have bullnose tiles, what is your...

If you don't have bullnose tiles, what is your plan for the other edges in your shower?

Have you checked to see if BN tiles are available with your tiles?
Forum: Tile Forum/Advice Board 01-14-2021, 10:39 AM
Replies: 47
Views: 1,251
Posted By Davy
Matt, Ditra heat wires are probably larger in...

Matt, Ditra heat wires are probably larger in diameter than Warm up. Of course the Ditra heat wires fit nicely in the Ditra mat which keeps the floor nice and flat without wires sticking up. Years...
Forum: Tile Forum/Advice Board 01-13-2021, 07:41 PM
Replies: 31
Views: 608
Posted By Davy
I've never used Kerdiboard but can you remove...

I've never used Kerdiboard but can you remove tiles off of it without tearing a big hole in it?
Forum: Tile Forum/Advice Board 01-13-2021, 07:25 PM
Replies: 12
Views: 308
Posted By Davy
These are 4x16 tiles and since they did have a...

These are 4x16 tiles and since they did have a slight bow, I went with a 1/3rd stagger. To also help, I made the joints 1/8 wide. I went over this with the homeowner ahead of time so they weren't...
Forum: Tile Forum/Advice Board 01-13-2021, 08:26 AM
Replies: 11
Views: 406
Posted By Davy
I've built a speed bump in several showers across...

I've built a speed bump in several showers across the doorway. Best I remember, the one below is 5/8-3/4. That way the door will open over a mat.
Forum: Tile Forum/Advice Board 01-13-2021, 08:07 AM
Replies: 8
Views: 227
Posted By Davy
I'm with the others, I wouldn't let them caulk...

I'm with the others, I wouldn't let them caulk it. When installed, it should be set level and flat.
Forum: Tile Forum/Advice Board 01-12-2021, 08:21 AM
Replies: 7
Views: 194
Posted By Davy
You might think about cutting a piece of...

You might think about cutting a piece of cardboard that's just big enough to wedge in that space. Keep it within an inch or two of where you need to chisel. Then, once you're done chiseling, vacuum...
Forum: Tile Forum/Advice Board 01-11-2021, 08:57 AM
Replies: 31
Views: 799
Posted By Davy
I wouldn't redo the patch. I think it'll be fine....

I wouldn't redo the patch. I think it'll be fine.

Yes, buy the right Schluter trim that fits your tile thickness.

You are right. You won't be able to get the pattern to flow from the back wall...
Forum: Tile Forum/Advice Board 01-11-2021, 08:42 AM
Replies: 31
Views: 1,136
Posted By Davy
From my experience, I've found that it's best to...

From my experience, I've found that it's best to buy silicone that is supposed to match the grout you're using. All whites are not the same. I've found that the GE brand is a whiter white than even...
Forum: Tile Forum/Advice Board 01-10-2021, 05:27 PM
Replies: 11
Views: 204
Posted By Davy
I see no reason tape and bed mud wouldn't work....

I see no reason tape and bed mud wouldn't work. Get it as flat as you can and lightly sand it if it needs it. I'd let it set and paint a coat of Eco Prim grip on it. Custom's also has their own...
Forum: Tile Forum/Advice Board 01-10-2021, 04:56 PM
Replies: 11
Views: 218
Posted By Davy
Hi Nick, welcome back. I'd go ahead and bust more...

Hi Nick, welcome back. I'd go ahead and bust more concrete out along with some dirt, then post another picture. Is the drain already centered or do you need to move it?
Forum: Tile Forum/Advice Board 01-09-2021, 09:48 PM
Replies: 8
Views: 263
Posted By Davy
I count 10 or so nail holes in the top of the...

I count 10 or so nail holes in the top of the curb and there's probably more on the inside of the curb. Even if you were planning to go back with a traditional pan liner installation, I'd recommend...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 08:39 AM.


Sponsors

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright 2018 John Bridge & Associates, LLC