Ceramic Tile Advice Forums - John Bridge Ceramic Tile

Welcome to John Bridge / Tile Your World, the friendliest DIY Forum on the Internet


Advertiser Directory
JohnBridge.com Home
Buy John Bridge's Books

Go Back   Ceramic Tile Advice Forums - John Bridge Ceramic Tile > Search Forums

Sponsors


Showing results 1 to 25 of 96
Search took 0.01 seconds.
Search: Posts Made By: SWB04
Forum: Tile Forum/Advice Board 08-15-2021, 08:21 PM
Replies: 14
Views: 968
Posted By SWB04
Siding&Foundation Transition issues

First off, I'm treating all flashing and moisture prevention issues for this project pretty much the same as installing stucco on a wall. I'm installing a scratch coat over prepared surfaces,...
Forum: Tile Forum/Advice Board 06-30-2021, 05:58 PM
Replies: 14
Views: 968
Posted By SWB04
Well definitely look into the ACRYL 60. Thanks...

Well definitely look into the ACRYL 60. Thanks for the tip.

The MSV Manufacturer (Selkirk Stone) basically replied to my follow-up, "waterproofing pre-scratch coat is fine", just like MVMA...
Forum: Tile Forum/Advice Board 06-30-2021, 03:35 AM
Replies: 14
Views: 968
Posted By SWB04
"What Cx said about the S mortar. It just doesn't...

"What Cx said about the S mortar. It just doesn't have the bonding strength." - Davy

Readdressing the question back to the manufacturer.

I have a pallet of Type-S (Amerimix 400) in my garage,...
Forum: Tile Forum/Advice Board 06-30-2021, 03:24 AM
Replies: 14
Views: 968
Posted By SWB04
"Scott, I haven't yet figured out just what...

"Scott, I haven't yet figured out just what you're doing there.

First, are you putting this faux stone veneer only on the exposed concrete portions of what we see in your photos? You talk about...
Forum: Tile Forum/Advice Board 06-28-2021, 10:02 PM
Replies: 14
Views: 968
Posted By SWB04
New question (more or less), covering what I...

New question (more or less), covering what I discussed in section 1.

Does exterior concrete require a vapor/moisture barrier, before installing the Type-S scratch coat?


As mentioned...
Forum: Tile Forum/Advice Board 06-27-2021, 12:13 AM
Replies: 12
Views: 1,306
Posted By SWB04
Thanks for the help and advice, Dan. I learn...

Thanks for the help and advice, Dan. I learn something on this forum, for every project I do, and I posted the "after" pictures and comments mostly just to give back a little.

As far as the...
Forum: Tile Forum/Advice Board 06-26-2021, 07:10 PM
Replies: 14
Views: 968
Posted By SWB04
Thanks, John, for the info. So, I'll just...

Thanks, John, for the info.

So, I'll just leave the joint gap in the veneer, and use the same rubber mastic caulk to fill the gap that I used to seal the cold joint itself. Can't recall the name...
Forum: Tile Forum/Advice Board 06-23-2021, 05:34 PM
Replies: 14
Views: 968
Posted By SWB04
Person door - structural frame

In contrast to the garage door frame, the person door frame is "structural".

I say that the person door frame is structural, as in, door supporting (i.e. not load supporting). The doors hinges...
Forum: Tile Forum/Advice Board 06-23-2021, 05:30 PM
Replies: 14
Views: 968
Posted By SWB04
Garage door frame - will remove facia trim

I'll remove the facia inside trim, and then reinstall about 3" of it on the back of the door frame, after the lath, scratch coat, and stone are installed. I need the white faux frame to mount the...
Forum: Tile Forum/Advice Board 06-23-2021, 05:24 PM
Replies: 14
Views: 968
Posted By SWB04
Cold joint

Cold joint picture, FYI.
Forum: Tile Forum/Advice Board 06-23-2021, 05:23 PM
Replies: 14
Views: 968
Posted By SWB04
New Project: Cultured Stone veneer for home foundation

Introduction:

This is the largest project I've taken on to date. Installing stone veneer on the concrete foundation of the house. I have three questions now, but I'm sure they won't be the last...
Forum: Tile Forum/Advice Board 06-23-2021, 03:23 PM
Replies: 12
Views: 1,306
Posted By SWB04
More pixs

These are the tile install/installed pictures. Notes:

1) I used left over unmodified thinset for mudding the seams, i.e. the very gray stuff. I used ProLite High Bond Mortar (Home Depot, only...
Forum: Tile Forum/Advice Board 06-23-2021, 02:40 PM
Replies: 12
Views: 1,306
Posted By SWB04
Been meaning to do a final update on this ....

Never quite got it "finished" finished, always a little more to do, at least on my projects. However, I'll update with a few pictures in case they're of interest to anyone.

Here are some of my...
Forum: Tile Forum/Advice Board 04-16-2021, 06:49 PM
Replies: 12
Views: 1,306
Posted By SWB04
@KG (Bubba) That "gravel" CBU damage was...

@KG (Bubba)

That "gravel" CBU damage was caused by me. Post rant, after I slept on this, I decided to just treat this like a drywall repair. Cut out an 8" x 6" rectangle, and replace, probably...
Forum: Tile Forum/Advice Board 04-15-2021, 09:10 PM
Replies: 12
Views: 1,306
Posted By SWB04
Where's your spirit of adventure? Ahh,...

Where's your spirit of adventure?


Ahh, ya mean like when my plumber forgot to leak test a bathtub during construction, and I found out about that the day after drywall was complete, and the tub...
Forum: Tile Forum/Advice Board 04-15-2021, 12:42 PM
Replies: 12
Views: 1,306
Posted By SWB04
Thanks for the advice. The dry wall wasn't...

Thanks for the advice.

The dry wall wasn't contiguous. It was cut and separated (and therefore, flexed) at the countertop. I think that happened during the countertop installation, but as I...
Forum: Tile Forum/Advice Board 04-15-2021, 07:24 AM
Replies: 12
Views: 1,306
Posted By SWB04
Overkill? Durock over wall studs: Add Construction Adhesive?

Question: Should I add Construction Adhesive (probably a poly version) on the wall studs before installing the Durock CBU with CBU screws?

Project: Quartz ledgerstone panels over Durock CBU, for...
Forum: Tile Forum/Advice Board 05-26-2020, 12:33 AM
Replies: 39
Views: 3,287
Posted By SWB04
Apply mortar & backbutter, or backbutter only?

MSI recommends back-buttering their stack stone panels, which makes sense, since the back of these natural stone panels are uneven with many voids. MSI also recommends a 1/2 inch troweled bed of...
Forum: Tile Forum/Advice Board 05-21-2020, 01:13 PM
Replies: 39
Views: 3,287
Posted By SWB04
Oh..oh.. busted again by the moderator!! :bonk: ...

Oh..oh.. busted again by the moderator!! :bonk:

Yeah, I just wanted a quick answer, and no one in his right mind is gonna read 80 pages of my verbose narrative to get my new "Durock" question, at...
Forum: Tile Forum/Advice Board 05-21-2020, 12:45 PM
Replies: 39
Views: 3,287
Posted By SWB04
Thanks for the advice, and reminder. I've got a...

Thanks for the advice, and reminder. I've got a fire-hose charged and ready to wet that CBU down, real good. :rolleyes:

That's partly why it takes me so long to do a job. I read and research a...
Forum: Tile Forum/Advice Board 05-21-2020, 10:32 AM
Replies: 39
Views: 3,287
Posted By SWB04
Durock, smooth-side, vertical, will mortar stick??

I goofed on a small section of a Durock CBU install, flipping it from rough side to smooth side (after making a semi-complicated cut). I figure Hardiebacker is pretty smooth, and mortar sticks well...
Forum: Tile Forum/Advice Board 05-11-2020, 02:05 PM
Replies: 39
Views: 3,287
Posted By SWB04
Tiling near heat sources

That's the title of this Mapei technical note:
Tiling near heat sources (http://www.mapei.com/public/US/linedocument/TB_FAQ-Tiling_Near_Heat-EN.pdf)

I've discussed my project in depth on the...
Forum: Tile Forum/Advice Board 05-10-2020, 08:33 PM
Replies: 39
Views: 3,287
Posted By SWB04
Thanks Jim for your response. I had...

Thanks Jim for your response.

I had differing feedback on that product, so I did run this up the Custom Building Products support "flagpole" to get their input tomorrow. I had been planning on...
Forum: Tile Forum/Advice Board 05-10-2020, 04:08 PM
Replies: 39
Views: 3,287
Posted By SWB04
"I don't think the face of this direct vent...

"I don't think the face of this direct vent sealed fireplace gets anywhere near as hot as a masonry wood burning fireplace. The heat is mostly contained inside the appliance, and vented through the...
Forum: Tile Forum/Advice Board 05-08-2020, 08:36 PM
Replies: 39
Views: 3,287
Posted By SWB04
For context. This is the target product for...

For context. This is the target product for installation, i.e. ledgerstone..

MSI Natural Earth Ledger Panel 6 in. x 24 in. Natural Slate Wall Tile...
Showing results 1 to 25 of 96

 
Forum Jump

All times are GMT -6. The time now is 01:03 AM.


Sponsors

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright 2018 John Bridge & Associates, LLC