Ceramic Tile Advice Forums - John Bridge Ceramic Tile

Welcome to John Bridge / Tile Your World, the friendliest DIY Forum on the Internet


Advertiser Directory
JohnBridge.com Home
Buy John Bridge's Books

Go Back   Ceramic Tile Advice Forums - John Bridge Ceramic Tile > Search Forums

Sponsors


Showing results 1 to 25 of 222
Search took 0.02 seconds.
Search: Posts Made By: Tile & Stone Guild
Forum: Professionals' Hangout Today, 07:02 AM
Replies: 7
Views: 132
Posted By Tile & Stone Guild
We have gotten back to normal in the last few...

We have gotten back to normal in the last few months. Occasional extra week wait on some material but nothing drastic. Local economy is quite strong right now, we have things lined up into the fall...
Forum: Tile Forum/Advice Board Yesterday, 05:31 AM
Replies: 10
Views: 300
Posted By Tile & Stone Guild
They leave the openings for these enclosure big...

They leave the openings for these enclosure big so they fit easy at install. I think you'll find that the wall is flare everywhere it meets the tub. If you cut the drywall be prepared it could end up...
Forum: Professionals' Hangout 01-21-2021, 03:33 AM
Replies: 14
Views: 663
Posted By Tile & Stone Guild
Ended up being just under $500 for the color,...

Ended up being just under $500 for the color, base not included. Not bad all things considered. 2 week turnaround
Forum: Professionals' Hangout 01-10-2021, 12:27 PM
Replies: 14
Views: 663
Posted By Tile & Stone Guild
No, really I couldn't find anyone who has heard...

No, really I couldn't find anyone who has heard of Grout 360. The cost of this shower is going to hit $120k+ and I'm not comfortable with something that doesn't have a review by any close peers. I...
Forum: Professionals' Hangout 01-10-2021, 11:38 AM
Replies: 14
Views: 663
Posted By Tile & Stone Guild
I haven't received a bill yet. I was told roughly...

I haven't received a bill yet. I was told roughly $300 line fee for setup, it's done after hours. You have to buy a case of the Perma select packets which are $60 per. Think there are 10 or 12 boxes...
Forum: Professionals' Hangout 01-09-2021, 05:50 PM
Replies: 14
Views: 663
Posted By Tile & Stone Guild
I ended up going through Laticrete, thanks again...

I ended up going through Laticrete, thanks again @Karls tile Inc
Forum: Tile Forum/Advice Board 01-08-2021, 04:42 PM
Replies: 18
Views: 472
Posted By Tile & Stone Guild
Any exterior deck we do has a roofer involved,...

Any exterior deck we do has a roofer involved, Troba mat, mudbed,ditra, and kerdi,You dont have room for that Personally I would not do this job based on your height issues and recommend getting a...
Forum: Professionals' Hangout 01-06-2021, 06:15 PM
Replies: 21,853
Views: 4,893,272
Posted By Tile & Stone Guild
Same shower without the LED backlights on, looks...

Same shower without the LED backlights on, looks quite different. Individual 4" fish scale tiles. 8hrs to run 35 sq ft floor, the walls and ceiling are going to be even slower.
Forum: Tile Forum/Advice Board 01-06-2021, 05:48 PM
Replies: 9
Views: 285
Posted By Tile & Stone Guild
I realize putting Kerdi over a pan lined with...

I realize putting Kerdi over a pan lined with Kerdi is redundant but it's a simple step. I do this regularly, other than time there isn't a reason to not do it.
Forum: Tile Forum/Advice Board 01-03-2021, 05:22 PM
Replies: 21
Views: 1,124
Posted By Tile & Stone Guild
The kerdi fix in a slit and then patch over is...

The kerdi fix in a slit and then patch over is fine. 2" overlap.

Looks like you are still running band, be sure to use inside and outside corners around and in your niche.
Forum: Tile Forum/Advice Board 01-02-2021, 08:54 AM
Replies: 11
Views: 340
Posted By Tile & Stone Guild
Some we pull from sheets and some we don't,...

Some we pull from sheets and some we don't, depends how they key together. If you can see the sheets when you lay them out than peel. Just from the pic they probably need to be peeled. I use a worn...
Forum: Professionals' Hangout 01-02-2021, 07:50 AM
Replies: 4,785
Views: 1,678,328
Posted By Tile & Stone Guild
Here is what I ripped out of a never been used...

Here is what I ripped out of a never been used shower. Waterproofed the clamping ring, weep holes, bolts etc. Also they used 2 pan liners and no pre slope. 2 years old and the waterproofing was still...
Forum: Professionals' Hangout 01-01-2021, 03:02 PM
Replies: 21,853
Views: 4,893,272
Posted By Tile & Stone Guild
This job has been sucking the life out of me....

This job has been sucking the life out of me. Hard part is over, about 2-3 weeks left to finish.
Forum: Tile Forum/Advice Board 12-31-2020, 03:37 AM
Replies: 15
Views: 3,085
Posted By Tile & Stone Guild
Schluters linear drains have kerdi attached to...

Schluters linear drains have kerdi attached to the drain it self. While I know it's a pain, pop a hole on the ceiling and attach the drain. Small drywall repair is worth the piece of mind.

Cutting...
Forum: Tile Forum/Advice Board 12-30-2020, 04:44 AM
Replies: 15
Views: 3,085
Posted By Tile & Stone Guild
You'll need to attach the line to the boot then...

You'll need to attach the line to the boot then glue to the trap. If you aren't comfortable doing it blind cut out the subflooring enough to install and then put the plywood back. Currently that's...
Forum: Tile Forum/Advice Board 12-26-2020, 07:16 PM
Replies: 35
Views: 946
Posted By Tile & Stone Guild
It can be installed in 2 pieces, it would be...

It can be installed in 2 pieces, it would be physically impossible to slide it in 1 piece as you have it in the pic.

Far as your contractor's time on the job it's a trust thing. It's not uncommon...
Forum: Tile Forum/Advice Board 12-26-2020, 04:17 PM
Replies: 35
Views: 946
Posted By Tile & Stone Guild
Even if they can cut the piece it is still not...

Even if they can cut the piece it is still not something that can be installed. When we do panels like this all doors and jambs are removed. If the layout is such that a cut needs a break such as...
Forum: Tile Forum/Advice Board 12-25-2020, 05:23 PM
Replies: 8
Views: 225
Posted By Tile & Stone Guild
Already been done https://stonetrash.com/

Already been done

https://stonetrash.com/
Forum: Tile Forum/Advice Board 12-22-2020, 03:32 AM
Replies: 9
Views: 285
Posted By Tile & Stone Guild
I do heated shower floors fairly often, doing one...

I do heated shower floors fairly often, doing one now. The off the record for smaller than 2" tile I was told kerdi should be applied on top of ditra. Personally I would not do it, because I dont...
Forum: Professionals' Hangout 12-20-2020, 04:17 PM
Replies: 14
Views: 663
Posted By Tile & Stone Guild
Thanks Karl, I'll look into that.

Thanks Karl, I'll look into that.
Forum: Tile Forum/Advice Board 12-20-2020, 04:09 AM
Replies: 27
Views: 907
Posted By Tile & Stone Guild
Power grout will pinhole if its washed to soon...

Power grout will pinhole if its washed to soon and or mixed to loose. I would see how much you can wallow the holes out and pack them again. Careful not to chip the tile.
Forum: Tile Forum/Advice Board 12-17-2020, 03:37 AM
Replies: 11
Views: 399
Posted By Tile & Stone Guild
Our consistency is closer to brick mortar, not...

Our consistency is closer to brick mortar, not quite as wet. 3-1 masonary with shovel of Portland
Forum: Tile Forum/Advice Board 12-16-2020, 05:35 PM
Replies: 12
Views: 379
Posted By Tile & Stone Guild
Last 2 photos look like the ditra wasn't embedded...

Last 2 photos look like the ditra wasn't embedded fully. Spotty thinset bleed through, I'll assume it wasn't put in with a roller and just done by hand.

I agree with cx,it doesnt take much for...
Forum: Tile Forum/Advice Board 12-16-2020, 05:27 PM
Replies: 11
Views: 399
Posted By Tile & Stone Guild
I'll pile on here and say if this is a first run...

I'll pile on here and say if this is a first run I would not. Keeping good coverage and adjusting mud consistency as the depth changes takes some experience and so does keeping good coverage...
Forum: Tile Forum/Advice Board 12-14-2020, 05:39 PM
Replies: 7
Views: 288
Posted By Tile & Stone Guild
The steam spouts need to be strapped well,...

The steam spouts need to be strapped well, punching a whole through the back may help determining if that's the issue. Whether or not you can do anything about it once you open the wall is a crap...
Showing results 1 to 25 of 222

 
Forum Jump

All times are GMT -6. The time now is 08:37 AM.


Sponsors

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright 2018 John Bridge & Associates, LLC