Ceramic Tile Advice Forums - John Bridge Ceramic Tile

Ceramic Tile Advice Forums - John Bridge Ceramic Tile (https://www.johnbridge.com/vbulletin/index.php)
-   Tile Forum/Advice Board (https://www.johnbridge.com/vbulletin/forumdisplay.php?f=1)
-   -   Grout issue (https://www.johnbridge.com/vbulletin/showthread.php?t=23948)

dmb 06-02-2005 01:45 PM

Grout issue
 
Finished the grout job over the weekend.

Looks pretty good for a novice.

Yesterday I noticed a variation in the grout.

Upon a close look it looks like some of the old wax from the toilet got into the grout upon spreading.

It is just half the width of the grout line and about 1/2 inch long, not large but right in the middle of the floor and darker than the rest of the grout. It is also very soft because of the wax.

Is the only way to fix it to remove an inch or two of the grout and put a little new grout down?

Am I better off just leaving it?

Any thoughts on this? I'm inclined to remove a bit and replace the grout. It would drive me nuts if I didnt try something.

You have been helpful so far, any thoughts on this?

Thanks!

Dave

jdm 06-02-2005 02:36 PM

Dave --

If it is wax in there, you should indeed get it out. Dig out that bit of grout and replace it. Try to mix the new grout to the same consistency as the original to improve the chances of getting a good color match.


All times are GMT -6. The time now is 08:42 AM.

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright 2018 John Bridge & Associates, LLC