Ceramic Tile Advice Forums - John Bridge Ceramic Tile

Ceramic Tile Advice Forums - John Bridge Ceramic Tile (https://www.johnbridge.com/vbulletin/index.php)
-   Professionals' Hangout (https://www.johnbridge.com/vbulletin/forumdisplay.php?f=4)
-   -   Rubi Bridge Saw (https://www.johnbridge.com/vbulletin/showthread.php?t=118075)

TileFreak 11-09-2015 04:54 PM

Rubi Bridge Saw
 
I need to cut 24"x24" 3/4" thick porcelain tile on diagonal.

I would also like a saw that I could utilize for a lot of the woodplank-look tile.

I am considering the Rubi DC250-1200. Has anyone tried this saw? Pros/Cons/Suggestions?

bc brick john 11-12-2015 06:08 PM

i have a rubi 250-n which i got used $400 yr old
it only gives a rip of 900mm
and at first it was ok but its now cutting off by over 1/8 to 1/4 with
what ever blade i put in it so it sitting.
i hate the on/off position switch and had one fail costing over $100 to replace.

its not very good either with an over size gap between bed's so doing small cuts is a bit of a joke.

tile guide fence was a complete waste of space and i don't use it.

design of the fold in legs and lifting handle is a joke :shrug:
and the rolling wheels :shrug: unless its on a concrete or flat floor

i also have a 3' pearl bridge which is around the same sort of money

but there are better 3-4' rails saws out there now.
look at those but your going into 2K for most of them

tilemanct 11-13-2015 06:00 AM

I have my eye on a Ramondi Zipper. Have not seen one up close and personal yet. I wish my wallet would cooperate though.


All times are GMT -6. The time now is 09:11 PM.

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright 2018 John Bridge & Associates, LLC