Wedi ligno curbless system [Archive] - Ceramic Tile Advice Forums - John Bridge Ceramic Tile

PDA

View Full Version : Wedi ligno curbless system


vickyprodify
06-30-2019, 02:39 PM
Hi,
Newbie to the forum here

Im installing a curbless shower entry for our bathroom. As per the instructions i have the recessed subfloor done. However there is a 1/2" difference to the bathroom (outside the shower) floor.

I have a few questions.

1) Should I raise the level to flush by putting 1/2 ply over recessed subfloor? or
2) Is a 1/2" recess for shower area ok?
2a) if the recess is ok? how do i waterproof the lip?


If I do raise it, how do i put the 1/2 ply over?
1) Glue it?
2) Mortar?
3) Screw ply to thw sub floor every 12"?

Now for a wedi ligno pan question. I nees to bring it down to 32" from 36".
q
1) Can i cut the Wedi board 1" on one side and 3" on the other?

Sponsored Links


John Bridge
07-01-2019, 06:35 AM
Hi Vignesh, :)

Use 1/2 in. plywood to raise the floor drive screws 8 in. apart in both directions into the layer below. Try to avoid the joists.

I have never installed a Wedi floor and will let someone else answer that question. :)

John Bridge
07-01-2019, 06:36 AM
Hi Vignesh,

Add 1/2 in. plywood. Drive screws 8 in. apart in both directions. Try to avoid the joists and screw only into the layer below.

I have never installed a Wedi floor. :)

KiwiTiler
07-01-2019, 11:20 PM
Re cutting wedi down, don't exceed 6 inches on either side as more weakens the board structure.

You'll be fine.

Mark

Tiger Mountain Tile Inc
07-02-2019, 07:10 PM
I think what you are saying is that the subfloor is only recessed 1/2 inch? I don't understand why that would be. Is your subfloor 5/8 inch thick plywood or 3/4 inch thick OSB?