View Single Post
Old 10-26-2017, 07:27 PM   #62
mark999
Registered User
 
Join Date: Aug 2013
Location: st louis mo.
Posts: 259
1) are these installers the same hacks that did the first shower?
2)Is there a piece of the membrane tying together the curb to the wall,can not see it in the pitcher. All seams need to be overlapped by at least 2 inches.
3) was the pan set very level? The pitcher looks like it is sloping. Check to make sure you have 1/4 inch per foot slope to th drain from all directions.
4)does the curb slope in towards the drain? If they tell you they will slope the tile while thinsetting them I would tell them to pack up their tools and not come back.The slope should be done BEFORE the membrane goes on. Same with the bottom shelf of the niche. If not water will seep thru the grout and just sit there or run backwardsif slighly sloped back the wrong way.

And as i mentioned in an earlier post and someone else recently I would make them do a flood test. The longer the better.
__________________
Mark
mark999 is offline   Reply With Quote