View Single Post
Old 10-30-2006, 05:24 PM   #13
Ed-diy
Registered User
 
Ed-diy's Avatar
 
Join Date: Jun 2006
Posts: 98
Arrow

Hello again,

OK, I have checked out the SLC pour with a straight edge.
It's pretty good but I do have a low spot in the middle.
Thats where the thinset is the thinest. The SLC does not seem to flow well when it is less than say 3/16" or maybe 1/8" thick. No matter with a little versabond and a straight edge I should have a really flat floor.

Scooter, You told me I would have to touch it up with thinset to get it "dead flat". No doubt about it.

Shaughnn, I compromised. I used two buckets and I had everything set up with the water pre-measured.

Thanks again, now I better get back to work. I still need to improve the flatness, put down the NobleSeal CIS, and get some tile.
__________________
Ed
Ed-diy is offline   Reply With Quote