Tile Lab Sealant

[FM]

I recently sealed my tiles with Tile Lab and from what I have been reading that may have not been the best choice. I used a foam brush to apply and it didn't dry smoothly even after 2 coats. I did the counter top and it turned out fine. Same tile, etc. I was vacuuming and the brushes hit the tile and now I have brush marks on the tile floor. The sealant was done about 2 weeks ago so I would think it has had time to dry.
Should I try a different sealant over the Tile Lab? Can you strip the Tile Lab off and start over?
I have another bathroom that needs to have the floor sealed and don't want to make the same mistake.
I would appreciate any suggestion.
Thank you!!

[Sponsored Links]

[doitright]

Hi FM, Welcome! :)

You could try to reapply the Tile Lab product and buff dry. Do not allow the sealer to dry on the surface of the tile is the best advice we can offer.

[FM]

Thanks John,
Do I leave it on for a certain amount of time before I buff it dry and do I use a sponge or a cloth?
FM

[doitright]

Hi FM :)

The key is to let the product dissolve itself. A cloth would be the best thing to buff with.