I need achieve a "Wet look" on 24" Slate.

[Hamilton]

Ok well the title says most of it.
I have recently done a backsplash for some folks
who want me to enhance their 2200 ft of 24" slate.
I did a sample on 3 tiles in an area that is uncospicous.
I put 3 coats af Miracle sealants enhance & seal on
the tiles and im wondering if this particular product would
hold up over time. Ive been told enhancers will need to be
done on a yearly basis or more often if foot traffic is heavy.
Also the floor is grouted of course so i would have to seal
each tile invidually as ive never had good luck with enhancer
on grout. Can i use a regular sealer to seal the grout first
to avoid any funky discoloring in the grout , and last question
does anyone reccomend a different kind of sealer altoghter to
get the wet look on slate?

[Sponsored Links]

[justin savage]

we do alot of slate and all i use is Miracles "mira matte" .it gives the wet look ,i have tried some others but like this the best so far- reasonably priced also. justin

[doitright]

Hi Jack :)

If your clients like the glossy wet look, I like using Sparks Stone Glamor. You're right about the grout enhancing part. It sounds like it's already grouted.

[Hamilton]

How many coats are needed to get the needed wet look, and also
will it effect the grout, yes it is grouted?. Do you use a pump spray,
roller or sponge by hand? Thank you for helping :)

[doitright]

Hi Jack :)

One coat will get it off to a great start. Two may be needed to finish it off. This particular product has a minimal effect on the grout.

I usually brush it on. I'm sure a low pressure sprayer may work with the large area you have. I'd consider using a lambs wool applicator with the sprayer just to even out the finish.

You'll need plenty of ventilation and a respirator. The stuff is nasty.